Contents: Removal ↓ Installation ↓
Note: The illustrations show the replacement of the corrector servo drive lamp on the left headlight.
Note: The left servo drive and the right servo drive of the headlight corrector are replaced in a similar manner.
Removal
Remove the headlight.
Fig. 7.59. Protective cap
Remove the protective cap 1 (Fig. 7.59).
Fig. 7.60. Headlight corrector servo drive
Rotate the headlight corrector servo drive 1 in the direction of the arrow and remove the servo drive (Fig. 7.60).
Fig. 7.61. Servo plug
Disconnect plug 2 of headlight corrector servo drive 1 (Fig. 7.61).
Installation
Installation is carried out in the reverse order, taking into account the following.
Fig. 7.62. Installing the servo drive ball head into the guide
Carefully install the ball head of the headlight range control servo 1 into the guide, while pulling the reflector back (Fig. 7.62).
Now place the servo into the clamp and rotate it about 30° clockwise until it locks into place.
Note: When installing, pay attention to the tight fixation of the cap. If water gets inside the headlight, the headlight may be damaged.
Visitor comments