Instructions: To adjust the installation position of the headlight, it is not necessary to remove the front bumper. The right headlight is shown in the pictures. If, when checking the position of the headlight after its installation, uneven gaps are found between the headlight and the body, then its position must be adjusted.
Turn off the ignition and all electrical consumers, remove the ignition key. Remove the radiator grille. Loosen both bolts securing the "arrow" at the front of the headlight.
Loosen the "arrow" mounting bolt at the bottom of the headlight.
Loosen the "arrow" mounting bolt on the top of the headlight.
Adjust the position of the headlight relative to the body by screwing in or unscrewing the adjusting bushings "arrow". Tighten the bolted connections to the prescribed tightening torques. Check the position of the headlight again and adjust the gaps if necessary.
Check the operation of the headlight.
Instructions: After dismantling the headlight or adjusting it to the body, it is always necessary to adjust it.
Visitor comments