Instructions: It is not necessary to disconnect the ground from the battery. The headlights can be removed without removing the front bumper. The illustrations show the removal or installation of the right headlight. If the headlight was removed, then after installation the headlight must be adjusted.
Switch off the ignition and all electrical consumers, remove the ignition key. Remove grille. Unlock and disconnect connector -arrow-.
Unscrew the four securing bolts -arrows A- and -arrows B- and remove bracket -1-.
Unscrew upper and lower securing bolt -arrows- at front of headlight.
Unscrew securing bolt -arrow- at rear of headlight and pull headlight upwards out of body opening.
Installation is carried out in the reverse order. When installing the bracket -1-, observe the tightening sequence for the fastening bolts. Tighten bolts -arrow A- first, then bolts -arrow B- to specified torque. Check the installation of the headlight for the same side clearances. If the gaps between the headlight and the body are uneven, the position of the headlight must be corrected. Check headlight operation.
Visitor comments