Removing
1. Remove the decorative panel of the heater and air conditioner control unit. To do this, using a screwdriver with a thin blade, wring out the latches located at the corners of the panel.
2. Unscrew the 4 screws securing the heater and air conditioning control unit.
3. Disconnect the electrical connectors from the control unit.
Installation
1. Before installation, check the smoothness of the control cables and, if necessary, replace them.
2. To facilitate identification, the sheaths of the control cables are of different colors.
3. Put on the rounded ends of the cables (1) on the levers (2) control the heater and air conditioner, and attach the cable sheaths to the control unit housing.
4. Connect the electrical connector to the control unit.
5. Insert the control unit with connected cables into the instrument panel.
6. Install and screw the heater panel with two screws.
7. Screw in the four screws securing the heater and air conditioning control unit.
8. Insert the decorative panel of the control unit until it is clearly fixed.
Visitor comments