Removal and installation of the engine control unit (petrol engine) (VW Touareg 1)

Contents: Removal ↓ Installation ↓

If it is necessary to replace the engine control unit, connect the VAS 5051B diagnostic tester and perform the guided function "Replace control unit".

Removal

Turn off the ignition.

Remove the windshield wiper motor on the right side.

Unlock both connector plugs from the engine control unit and disconnect them.

Now the control unit can be removed.

Installation

Insert the control unit into the mounting frame.

Connect the plugs and secure them.

Install the windshield wiper motor on the right side.

Install the casing of the water drainage box.

Match the new engine control unit.

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

The text has been checked: Tarasov Ivan

Previous articles
Checking the fuel pressure regulator and residual pressure (petrol engine)
Checking the amount of fuel injected (petrol engine)
Checking injectors (petrol engine)
General instructions for the injection system (petrol engine)

Next articles
Removal and installation of the engine control unit with anti-theft protection (petrol engine)
Checking and adjusting the position of the pump-injector pistons (diesel engine)
Removal and installation the intake manifold (diesel engine)
Removal and installation of the pump-injector (diesel engine)
Replacing the O-rings of the pump-injector (diesel engine)

Link to this page in different formats

HTMLTextBB Code

Visitor comments

No comments yet