Contents: Removal ↓ Installation ↓
Removal
Remove the inner door trim.
Roll the window glass down.
Remove the inner and outer triangular covers.
Unscrew the window glass guide -14 - and pull it out of the window shaft upwards.
Detach the window glass from the window lifter
Installation
Note: If a new window glass is being installed, fit the window regulator rail onto it: dimension "a" must be 384 mm.
Place the window glass from above into the door shaft.
Secure the glass to the window regulator, do not tighten the screws.
Raise the glass all the way up and then lower it again until the screws are visible in the mounting hole.
Tighten the screws to 7 Nm. Install the inner door trim.
Visitor comments