GT model
- 1 - lower side member lining
Removal: Drill out the rivet heads, including the lower head of the rivet for fastening the outer contour lining of the wheel arch. Press down the locking tabs of the holders "3". Turn the lining outwards at the bottom and remove it from the holder rail with an upward movement. Installation: Insert the side member linings under the outer contour linings of the wheel arches. In doing so, ensure that the front lining in the transition zone lies on top of the rear lining. Attach and rivet the side member linings using riveting pliers.
- 2 - hollow rivet
- 3 - holder with fixing protrusions
The holder is glued.
- 4 - holder bus
The tire is glued.
- 5 - cutouts for fixing protrusions
[The article is posted on the portal: www.VWmanual.ru]
Visitor comments