Passat Variant
- 1 - roof rail base overlay
Removal: Starting from the front, lift with a plastic wedge and pull forward from under the rear cover.
Installation: replace the clamps, insert the pad from the front and hit it into the clamps with your palm.
- 2 - roof rail overlay
Removal: Unscrew the Allen bolts securing the grab handle. Starting from the front, lift with a plastic wedge and pull forward from under the rear cover.
Installation: replace the clamps, insert the pad from the front and hit it into the clamps with your palm.
- 3 - clamp
Replace after each removal of the lining. To replace, stretch the clamp with a screwdriver and remove.
- 4 - back cover
Glued, clean the surfaces to be glued. Remove the protective paper from the new cover and press the cover to the roof. When reinstalling, use double-sided adhesive tape, do not remove the old foam tape.
- 5 - protective paper
- 6 - foam adhesive tape
- 7 — mounting position
Gap without roof railing - 4 ±2.5 mm; with roof railing - 5 ±2.5 mm.
- 8 - T-pin
- 9 — roof frame edge
- 10 - windshield frame
- 11 - roof frame
- 12 - Allen key bolt, 10 Nm
Visitor comments