Removing
Place the car on a lift.
Disconnect the wire from the negative battery terminal.
Install the clamps on the coolant supply hoses to the transmission oil cooler.
Disconnect hoses from oil cooler.
Place a stand under the front of the vehicle.
Remove the upper engine mount bracket.
Disconnect the flexible speedometer drive shaft from the gearbox.
Attach the hoist to the engine and hang the engine.
Remove the upper bolts securing the gearbox to the engine block.
Remove the starter and unscrew the three bolts securing the torque converter to the flywheel drive flange.
Disconnect the front wheel drives and hang them to the body.
Disconnect the exhaust pipe from the exhaust manifold.
Remove the mounting bracket for the front muffler pipe to the gearbox.
Remove the exhaust pipe from the mufflers.
Remove the upper support, return spring and disconnect the selector lever cable.
Remove the throttle control rod.
Loosen the positive shift cable and disconnect it from the transmission bracket.
Unscrew the oil filler pipe, having previously placed a container under the gearbox to drain the oil.
Loosen the nuts securing the gearbox mounts to the front subframe.
Install a suitable jack and raise the gearbox.
Loosen the lower bolts securing the gearbox to the engine block.
Slightly move the gearbox away from the engine, but so that the torque converter remains in the crankcase.
Remove gearbox.
Fix the torque converter in the crankcase.
Installation
Before installing the automatic transmission, put in place (see below) torque converter. Make sure that it does not move when installing the gearbox.
Install the gearbox on the car.
Install the lower gearbox-to-engine block bolts.
Tighten the nuts of the bolts securing the gearbox mounts to the front subframe.
Install the oil fill tube.
Connect the positive shift cable to the gearbox.
Install the throttle control rod.
Attach the selector lever cable and install the return spring and upper support.
Install the muffler exhaust pipe. At the same time, put a new gasket between the flanges of the pipe and the exhaust manifold.
Install the front wheel drive shafts.
Install the upper engine mount bracket.
Install and tighten torque converter to flywheel drive flange bolts.
Install starter.
Install and tighten the upper gearbox-to-engine block bolts.
Disconnect the lifting device from the engine.
Attach the flexible speedometer drive shaft.
Attach the hoses to the oil cooler and remove the clamps from the hoses.
Restore the coolant level in the expansion tank.
Pour oil into the automatic transmission.
Connect the wire to the negative terminal of the battery.
Details of the automatic transmission housing:
1 - differential housing;
2 - torque converter cover;
3 - bearing support of the drive gear of the final drive;
4 - lower cover of the torque converter housing;
5 - gearbox housing;
6, 7 - sealing rings;
8 - oil pan;
9 - oil filling tube and oil level indicator tube;
10 - differential bearing cover;
11 - stuffing box.
Visitor comments