Contents: Removal ↓ Installation ↓
Removal
1. Heat moldings 1-4 with a hair dryer and gradually and evenly detach them (see illustration).
Installation
Attention! Optimal conditions for gluing are provided at an air temperature of +21°C. The mounting holes on the right and left moldings are located differently.
2. Clean the surfaces to be bonded with gasoline, treat with silicone remover and wipe dry.
[The original article is posted on the website: www.VWMANUAL.ru]
3. Remove the protective foil from the self-adhesive molding.
4. Fix moldings 1-4 to stops 2 and 3 by inserting them into the holes in the body, press them evenly, and then press them for final fixation (see illustration 47.1).
Attention! The final drying of the adhesive layer requires approximately 4 hours at an air temperature of +21°C.
Visitor comments