Rear suspension of front-wheel drive vehicles
- 1 - shock absorber;
- 2 - spring;
- 3 - beam;
- 4 - upper spring support;
- 5 - shock absorber support;
- 6 - buffer;
- 7 - brake disc;
- 8 - bearing;
- 9 - anti-roll bar;
- 10 - rubber-metal support;
- 11 - handbrake cables
Elements of the rear suspension of front-wheel drive vehicles
- 1 - wheel mounting bolt, 120 Nm;
- 2 - Phillips head screw;
- 3 - brake disc;
- 4 - dust cap. After each removal of the cap it must be replaced. Only when installing a new cap is a proper seal ensured;
- 5 - self-locking twelve-sided nut, 175 Nm. A new nut must be used during installation;
- 6 - wheel hub with bearing;
- 7 - bolt 60, Nm. When installing, it is necessary to use a new bolt;
- 8 - brake shield;
- 9 - bracket for handbrake cables;
- 10 - handbrake cable;
- 11 - self-locking nut, 80 Nm. A new nut must be used during installation;
- 12 - bolt, 75 Nm. A new bolt must be used during installation;
- 13 - bolt, 80 Nm. A new bolt must be used during installation;
- 14 - rear beam support bracket;
- 15 - Handbrake cable holder;
- 16 - rubber-metal support;
- 17 - rear beam;
- 18 - wheel speed sensor;
- 19 - Allen bolt, 8 Nm;
- 20 - support;
- 21 - spring;
- 22 - Upper spring support;
- 23 - bolt, 60 Nm. A new bolt must be used during installation;
- 24 - bolt, 75 Nm. A new bolt must be used during installation;
- 25 - shock absorber;
- 26 - Nut. When installing, it is necessary to use a new nut, tighten the nut to the required torque with the car standing on the ground and with one person in the back seat;
- 27 - hub journal;
- 28 - protective cover;
- 29 - Allen bolt, 65 Nm. A new bolt must be used during installation;
- 30 - brake caliper
The main element of the rear suspension is a beam with welded levers. A stabilizer is installed in front of the rear beam, which reduces the roll of the car on turns. The rear beam is attached to the body through rubber-metal bushings. Separately located springs and shock absorbers are used to cushion the rear beam. As a result of the separate location of the rear suspension springs, the volume of the luggage compartment has increased.
Warning: Welding and straightening work is not allowed on the load-bearing elements of the rear suspension. When installing, it is necessary to use new self-locking nuts and replace bolts that have traces of corrosion.
Visitor comments