During all work related to the engine power system, maximum cleanliness should be observed, and the following recommendations should be followed:
- Outdoor work can only be carried out on calm days to avoid dust getting into the components and parts of the system.
- All fasteners must be thoroughly cleaned before unscrewing.
- Removed components and parts are placed on a clean table and covered with clean, lint-free materials,
- All open or partially dismantled components and parts of the fuel injection system that will not be serviced or repaired at the moment should be securely well covered or stored in a closed container,
- Before installation, check the cleanliness of all components and parts.
- If a part of the equipment is open, do not use compressed air to blow out any elements.
- If part of the system is removed, the car is not recommended to be moved.
- Pay attention that oil does not get into the hoses of the cooling system. If oil gets on the hoses, wipe them off immediately. Damaged hoses must be replaced.
Visitor comments