Removing
Drain the coolant.
Remove the cooling system hoses from the fittings.
Disconnect the connector from the coolant temperature sender G62.
Unscrew the fixing bolts of the fitting of the cooling system.
Push the cylinder connectors in the direction of the arrow into the cooling system fitting 1 (pic. 2.246).
Installation
Installation is carried out in the reverse order, paying attention to the following.
Replace seals 2 and o-rings.
Tighten the fixing bolts of the cooling system fitting 1 with a torque of 8 Nm.
Fill with coolant.
Visitor comments