1. The fuel filter is installed on the pump tank.
2. Disconnecting the wire clamp to the battery ground.
3. Raise the rear of the car and put it on stands.
4. Loosen the bolt of connection 23, the flexible pipe of the pressure accumulator and disconnect the connection, not forgetting the washers (gaskets) from two sides.
5. On the back of the filter, disconnect the flexible fuel supply pipe 17 (to the fuel distributor), by unscrewing the connection bolt. Remove washers from both sides.
6. Loosen the filter retaining clip 24 and remove the filter.
7. Installation takes place in the reverse order of removal. The washers at the ends of the connections must be replaced with new ones. Check whether the arrow on the filter points in the direction of fuel flow from pressure accumulator 1 to fuel distributor (compound 17).
8. With the engine running, check for signs of fuel leakage.
Visitor comments