Here is a picture of the injector installed on the engine: 1 - high pressure fuel line; 2 - rubber cap on the free nipple of the fuel drain line, only near the left injector, if you look in the direction of travel; 3 - drain pipe; 4 - nozzle.
Remove high pressure lines completely.
Remove the drain pipes.
Remove the injectors using a SW 27 socket wrench.
Thermal insulation washer (it sits in the nozzle hole) push out with a ballpoint pen or wire.
During installation, insert a new thermal insulation washer.
Each time you remove it, you must renew the heat-insulating washer under the injectors! Installation position: the arrow points to the cylinder head.
The original text can be found on the portal: vwmanual
Tighten the nozzle with a torque of 70 Nm. Connect the high-pressure pipes with a torque of 25 Nm.
Visitor comments