If the brake hose is secured with a clamp near the body, then it is held by a clamp from shifting in different directions. When assembling, do not forget about the clamp (see picture below).
There is a clamp (2) between the brake hose (1) and the brake pipe (3). This should not be forgotten during installation.
When installing the hose, you should always start fastening it at the place where it has an external thread.
Then tighten the other threaded connection.
The brake hose must not be allowed to twist. A colored strip or rubber piece can be used for control (along the hose).
(The article is posted on the portal www.VWMANUAL.ru)
Bleed the brake system.
Check immediately after repair: perhaps the hose is damaged somewhere due to the movement of the springs.
Repeat this check after a long trip.
Visitor comments