Contents: Left cylinder head ↓ Right cylinder head ↓
Left cylinder head
Disconnect the ignition coil and fuel injector connectors and set the wires aside.
Disconnect the plug from the Hall sensor.
Remove the sensor housing together with the plug and cone.
Right cylinder head
Remove the right timing belt cover.
Disconnect the plug from the Hall sensor.
Remove bolts 1 from the Hall sensor. Remove bolts 2 from the rear timing belt cover (fig. 2.122).
Pull the rear timing belt cover slightly forward and remove the Hall sensor housing together with the plug and cone.
Tighten pin 2085/1 as shown in Figure 2.123.
Unscrew the inner part of the seal puller 2085 a few turns from the outer part and secure with a knurled bolt (fig. 2.124).
Lubricate the threaded head of the puller with engine oil, apply it and, pressing it firmly, screw it as deep as possible into the seal.
Loosen the knurled bolt and rotate the inside of the puller against pin 2085/1 until the seal is removed.
Clamp the seal puller in a vice along the flat edges. Use pliers to remove the seal.
Finally, press in the new oil seal using mandrel 3241/1 and bolt 3241/3 flush (fig. 2.125).
The original text can be found at: vwmanual.ru
Further installation is carried out in reverse order.
Visitor comments