- 1 - Enclosure with soundproofing screen for soundproofing
- 2 - Intake air soundproofing
- 3 - Air intake sleeve, fix with spring clamps
- 4 - 7 Nm, self-tapping screw. Tighten the fastening screw with a screwdriver only if the speed of the screwdriver does not exceed 500 rpm and the tightening torque is not more than 7 Nm
- 5 - 7 Nm
- 6 - 7 Nm, self-tapping screw. Tighten the fastening screw with a screwdriver only if the speed of the screwdriver does not exceed 500 rpm and the tightening torque is not more than 7 Nm
- 7 - O-ring, replace
- 8 - Pressure pipe
- 9 - Noise isolation
- 10 - Enclosure for noise screen
- 11 - Sound insulation for charge air with sealing ring, replace the sealing ring between the compressor and sound insulation
- 12 - Compressor belt pulley
- 13 - 8 Nm
- 14 - Coolant pump with magnetic compressor clutch -N421-
- 15 - V-ribbed compressor belt. When installing the poly V-belt, pay attention to the direction of travel and the correct fit on the pulleys and tensioner
- 16 - 23 Nm
- 17 - Tensioner for compressor V-ribbed belt, loosen with a wrench, secure with locking pin -T10060 A-
- 18 - 40 Nm and tighten by 90°. To loosen and tighten the mounting bolt, hold the compressor shaft with a wrench, replace
- 19 - Compressor
- 20 - 25 Nm
Visitor comments