Instructions: Secure all hose connections with clamps that match those installed at the factory. Degrease hose connection pipes and supercharging system hoses before installation. Only the sealing ring and seat surface of the union connections should be lightly oiled. The supercharging system must be airtight.
- 1 - Intercooler
- 2 - 5 Nm
- 3 - Intercooler support
- 4 - Sealing ring, replace if damaged
- 5 - Charge air supply hose
- 6 - Intake manifold pipe with lip seal
- 7 - Air flap unit "J338". When replacing, delete the adaptation parameters in the memory and re-adapt the engine control unit "J623"
- 8 - 7 Nm
- 9 - Hose clamp
- 10 - Charge air supply hose
- 11 - 10 Nm
- 12 - Charge air pipe
- 13 - Boost pressure sensor "G31" with intake air temperature sensor 2 "G299"
- 14 - 5 Nm
- 15 - Turbocharger boost air supply hose
- 16 - Charge air pipe
- 17 - Charge air supply hose
The information is posted on this website (VWmanual)
Visitor comments