- 1 - Gasket, replace
- 2 - 15 Nm and tighten by 90°, replace. First install the left upper and right lower bolts, then the rest and then tighten all four crosswise
- 3 - Oil filter bracket, provide sufficient space to surrounding components and parts
- 4 - O-ring, replace
- 5 - Connecting nipple
- 6 - Oil supply line, 22 Nm, to turbocharger
- 7 - Oil pressure sensor "F1", 22 Nm. Marking; brown, 0.7 bar. If not tight, cut and replace the sealing ring
- 8 - Locking cap, 25 Nm
- 9 - O-ring, replace
- 10 - Filter element, observe replacement intervals
- 11 - O-ring, replace, lubricate before installation, snap into oil cooler retainers
- 12 - Oil radiator, ensure sufficient space to surrounding components and parts
- 13 - O-ring, replace
- 14 - Locking cap, 25 Nm
- 15 - 10 Nm
- 16 - Wiring harness bracket
Visitor comments