Pic. 6.60. ABS components on the front axle: 1 - ABS speed sensor; 2 - a bolt with an internal hexagon, 8 Nm; 3 - wheel bearing / wheel hub assembly; 4 - drive shaft
Removing
Raise the vehicle.
Pic. 6.61. Plug-in connection for speed encoder cable and speed encoder
Disconnect plug connection 1 of speed sensor cable and speed sensor (pic. 6.61).
Remove bolt 2 from wheel bearing housing.
Remove the ABS speed sensor from the wheel bearing housing.
Installation
Before installing the speed sensor, clean the inside of the hole and lubricate the sensor around the perimeter with grease G 052 112 A3.
Insert the speed sensor into the bore of the wheel bearing housing and tighten the bolt to 8 Nm.
Connect the frequency encoder to the encoder cable.
Visitor comments