Put a new protective cover on the shaft. Put a spring washer on the shaft with the concave side towards the joint. Clean the inner joint and put 120 g of grease in it.
Using a press, press the inner joint onto the shaft, directing its chamfered end forward. Install a new retaining ring. Push the protective cover into place and secure it with clamps, observing dimension "C" indicated in Fig. 4-82.
Fig. 4-82. Installing the protective covers for the inner joints of the front wheel drive shafts:
I — left wheel drive shaft; C = 17 mm;
II — right wheel drive shaft.
1 - ventilation chamber;
2 - ventilation hole.
Visitor comments