Fig. 9-30. Rear bumper parts:
1 — rear bumper cars with a "sedan" body;
2 - rear bumper of cars with a "station wagon" body;
3 - amplifier;
4 - protective pad;
5 - beam;
6 - side guide;
7 — bracket;
8 — mounting bolt (in the luggage compartment);
9 — plug on vehicles with a trailer towing hitch;
10 — plug for the installation location of the coupling device.
Raise the rear of the vehicle and place it on stands.
[The original article is available at: www.vwmanual.ru]
While supporting the bumper, loosen the five screws of the lower bumper mount (Fig. 9-31).
Remove the bumper by pulling it towards you and being careful not to damage the paintwork of the car. Install the bumper in the reverse order of removal. During a test drive on an uneven road surface, make sure that the bumper does not vibrate.
Visitor comments