Examination
Move the wiper arm to its original position. To do this, moisten the windshield with water, turn on the wiper for a short time and turn it off using the switch.
Remove the wiper blade see above.
Insert wiper arm -2- into special tool HAZET 4851-1 or VW-3358 and secure with bolt -3-.
Carefully place the lever together with the tool on the glass.
Attention: In this case, the tool must be in contact with the glass with all three reference points.
In this case, the tool shows the angle of inclination of the lever plane to the glass surface.
Prescribed tilt angle for the wiper arm
- driver's side
- up to 4/94: — -2.5°±2°
- from 5/94: — -4°±2°
(with plastic spoiler)
- passenger side: - 0°±2°
— at the rear door: — 0°±2°
Adjustment
If the measured angle of inclination does not correspond to the prescribed value, carefully turn the tool with a wrench -1- until the prescribed value is displayed on the scale.
Attention: When turning, lift the tool with the lever off the glass.
Remove the tool from the wiper arm, put it back on and lock it. Recheck the angle of inclination, repeat the adjustment if necessary. Repeat this process until the prescribed inclination angle is reached.
Remove the adjusting tool, install the wiper blade and check the angle of the next wiper arm in the same way.
Moisten the windshield with water and operate the wipers. Check wiper blades for rattling.
Visitor comments