Warning: Do not touch the lamp by the glass with bare fingers. Fingerprints, due to the heat emitted by the lamp, evaporate from the glass surface and then settle on the reflector surface, reducing its reflectivity. Replace the incandescent lamp only with a lamp of the same design. Remove stains accidentally caused by touching with a clean, lint-free cloth moistened with alcohol or spirits.
Turn off the switch of the corresponding lamp or disconnect the ground wire from the battery.
Open the engine hood.
Main headlight bulb H4
On the back of the headlight housing, turn the cover in the direction of the arrow and remove it.
Note: To replace the right lamp in vehicles with air conditioning, first unscrew screw "A".
Lift the air conditioning system pipe, pull it up and remove the air guide casing "B".
Disconnect the multi-pin plug.
Press the wire stopper "1" through the locking protrusions "2" and move it downwards.
Remove the defective lamp.
If necessary, remove the parking light bulb socket "3" from the reflector, having first disconnected the plug. Additionally shown part: 4 — ground connector at the reflector.
To make it easier to replace the lamp, you can look through the hole in the lock beam.
Main headlight bulb. D - inspection hole, E - multi-pin plug, F - wire stopper, G - bulb.
Parking light bulb: D — inspection hole, H — parking light bulb plug.
Press the parking light bulb into the socket, turn it to the left and pull it out.
Press the new parking light bulb into the socket, turn it to the right and lock it in place
Insert the cartridge into the reflector.
Insert the new main headlight bulb so that the projections on the bulb plate fit into the corresponding grooves in the reflector. The central pin on the bulb base should be at the top.
Secure the lamp with a wire stopper.
Connect the multi-pin plug and the parking light bulb plug.
Place the plastic cover "C" on the back of the headlight, turn it to the right and fix it. The inscription "oben" ("top") on the cover should face up.
If removed, insert the air guide housing and screw on the air conditioning line.
Check the adjustment of the main headlight.
Front turn signal light
The lamp can be replaced without removing the turn signal lamp.
Turn the lamp holder to the left and remove it.
The lamp is easy to press into the socket, turn to the left and remove from the socket.
Insert the new bulb, press it lightly into the socket and turn it to the right.
Fix the cartridge in the indicator body by turning it all the way to the right.
Check the operation of the new pump, having first connected the battery ground wire.
Close the engine hood.
Fog light bulb
Remove cover "1" from the housing.
Disconnect the ground connector "2" and the connector "3".
Unhook the spring stopper "4" and move it to the side.
Remove the lamp together with the socket from the housing.
Insert the new lamp so that the recess on the socket matches the jumper "5" on the housing.
Caution: Do not touch the glass of the lamp with your fingers.
Press the wire stopper and secure it in the grooves of the holder.
Insert the lamp wire into the wire connector.
Connect the electrical wires.
Install the back cover.
Visitor comments