Removing
1.. Disconnect transmitter 1 and key 2 (see illustration), by inserting a screwdriver into the slot and turning it in the direction shown by the arrows.
2. Slide transmitter 1 out of key holder 2 (see illustration).
3. Remove the battery from the compartment by prying it out with a small screwdriver.
Attention! When removing the battery from the compartment, make sure that the polarity is marked on the battery. Otherwise, mark the mounting position of the batteries in the compartment.
Installation
4. Place the battery in the compartment with the positive side facing down and push it down until it locks into place.
5. Replace the cover and attach the remote control transmitter to the key handle.
Be careful not to damage the seal while doing this.
Visitor comments