Disconnect the chassis cable from the battery.
Unplug the cable plug from the back of the car alternator. Pull the wire out of the disconnected clamp.
Loosen the V-belt tensioner, and loosen both vehicle alternator mounting screws.
Push the alternator inward and remove the V-belt.
Remove the car alternator fixing screw located on the underside and pull out the alternator.
The installation of the automobile generator takes place in the reverse order of dismantling, insert the V-belt into the grooves of the belt pulley and push the generator in the area of its suspension to the outside. While holding the vehicle alternator in this position, tighten the tie strap screw tightly. Check drive belt tension and adjust if necessary.
Visitor comments