1 - screw, 110 Nm
2 - nut, 70 Nm, when tightening the axis should be horizontal
3 - nut, 15 Nm
4 - leaf disk
5 - nut, 25 Nm
6 - lid (large)
7 - rubber ring
8 - lid (small)
9 - shock absorber strut
10 - wheel bearing
11 - nut, 80 Nm
12 - screw, insert from the center outward
13 - flange screw, 70 Nm
14 - rubber-metal support
15 - handbrake cable mounting unit
16 - bridge body
17 - anti-roll bar (if available)
18 - suspension support with brake pressure regulator mounting unit
The rear suspension consists of a rear axle beam, two coil springs and two hydraulic shock absorbers. Care must be taken to ensure that no welding is carried out on the rear axle axle and axle ends.
Visitor comments