Removing
Remove an internal upholstery of a door. Remove the protective film.
Lower and unscrew glass 5 (see fig. 465) or 9 (see fig. 466) windows from the glass lifting mechanism. Move the glass up.
Pic. 465. Front door from August 1987: 1 - handle; 2 - blocking rod; 3 - door lock; 4 - locking finger (installed on the middle rack); 5 - door glass; 6 - power window mechanism (tightening torque of its bolts 7 Nm); 7 - internal handle for opening the door; 8 - facing of the handle; 9 - thrust
Pic. 466. Front door before August 1987: 1 - door stop; 2 - inner glass lining; 3 - outer glass gasket; 4 - outer corner of the decorative cornice; 5 - corner glass; 6 - guide; 7 - lining of the glass guide; 8 - decorative cornice; 9 - glass; 10 - glass bracket; 11 - inner door handle; 12 - blocking rod; 13 - door lock; 14 - draft of the internal handle of opening of a door; 15 - facing of the handle; 16 - internal handle for opening the door; 17 - power window mechanism
Remove the power window, power window handle and vertical guide.
Pull the power window down out of the door.
Installation
Insert the window lifter, screw it and the vertical guide with four bolts with cup springs (tightening torque 7.0 Nm), screw on the power window handle.
Lower the glass and secure it to the window lifter.
Raise and lower the glass several times. If the glass moves with difficulty, lower the window lifter mounting bolts. Align the window lifter and tighten the bolts again.
Put the inner door trim, first glue the protective film carefully and without folds.
Visitor comments