Opening and closing the sunroof
When the ignition is on, the sunroof is controlled by a rotary switch.
Closing the electric sunroof
Turn the switch to position A (pic. 1.40).
Sliding sunroof panel
Turn the switch to position B. The sunroof panel will open to a certain, comfortable position, at which aerodynamic noise is minimal.
To further open the sunroof, turn the switch to position C and hold it in this position until the panel is in the desired position.
Sunroof panel lift
Turn the switch to position D.
Always close the sunroof fully when you park or leave your vehicle unattended.
After turning off the ignition, you can open or close the sunroof for another ten minutes if none of the front doors has been opened during this time.
Sun panel
The sun panel opens with the sunroof panel. It can also be moved with the sunroof closed.
WARNING: Careless handling of the sunroof can result in personal injury. Be careful when closing the sunroof. Otherwise, injury to yourself and others may occur! Always see if the sunroof can be safely closed first. Always take the key with you when you leave the car.
ATTENTION: Do not leave children and disabled people in the car with supervision, especially when the key is left in the ignition. Playing with the key can cause the engine to start or some electrical device, such as the power window, to be switched on - risk of injury! The car doors can be locked with the radio key, making it difficult to get help if needed.
IMPORTANT: The power sunroof operates until the key is removed from the ignition or none of the front doors are opened.
Electric sunroof overload protection
The electric drive of the sunroof panel is equipped with overload protection, which prevents the panel from pressing anything against the roof. Overload protection, however, does not completely eliminate the possibility of pinching fingers. If something interferes with the closing of the panel, it stops and returns back.
Such a returned to the open position panel can be closed if the rotary switch is in position A (pic. 1.40) keep tilted backwards until the sunroof is completely closed. Note that the panel now closes without overload protection.
If you still can't close the panel, you can close it manually.
Programmable remote control Using the memory buttons on the ceiling, you can, for example, program the remote control to open the garage door.
Via keys 1, 2 and 3 (pic. 1.41) you can program the remote control to perform individual functions, for example, to control the entrance gate, garage door, area lighting.
Programming
Press keys 1 and 3 and keep them pressed until the LED above key 2 flashes, then release the keys.
Install a radio key, for example, from a garage door, at a distance of about 5 cm in front of the keys.
Press the desired radio key key simultaneously with key 1, 2 or 3.
Keep both keys pressed until the LED flashes first slowly and then quickly.
Reprogramming one single memory key
Press key 1, 2 or 3.
Install a radio key, for example, from a garage door, at a distance of about 5 cm in front of the keys.
Press the desired key of your radio key simultaneously with key 1, 2 or 3.
Keep both keys pressed until the LED flashes first slowly and then quickly.
Using memory keys
Press key 1, 2 or 3 to activate the corresponding equipment.
Erasing all remote control programs
Press keys 1 and 3 and keep them pressed until the LED flashes quickly, then release the keys.
WARNING: Be careful when using the remote control. For example, when closing the garage doors, make sure that no one is in the movement area of the doors, otherwise serious injury may result.
Visitor comments