Removing
Remove the door handle.
Insert the key into the lock.
Loosen the Phillips screw. Remove the door lock cylinder eccentric and spring.
Attention! Be aware that the spring may pop out.
Pull out the door lock cylinder together with the key.
Attention! If the key is now removed, all locking pins will fall out of the cylinder. It is recommended to wrap the cylinder with adhesive tape. After that, you can remove the key.
Installation
Insert the door lock cylinder.
Put on the spring and tension it, sliding the end of the spring over the lug on the lock.
Put on an eccentric. At the same time, place it so that the spout on the fork lies between the ends of the spring and the eccentric is fully installed on the square. Screw in the Phillips screw.
Install the door handle.
Visitor comments