- 1. Fill both wheel bearings and the hub with universal grease.
- 2. If the brake hose has become loose, after installing it, check that there is sufficient space between the hose and the wheels. When turning completely left or right, the minimum distance should be 25 mm. If necessary, adjust the brake hose.
(ij brake disc
(2) hub cap
(3) Nut. After adjusting the clearance in the bearings, caulk
(4) pressure washer
(5) Outer wheel bearing. Knock out the rotating ring with a soft mandrel
(6) inner wheel bearing
(7) O-ring. Check for scratches
(8) lid
(9) Phillips head screw
(10) brake cushion
(11) cone bolt
(12) Hex bolt
(13) steering knuckle
(14) Upper hinge. Replace only if the rubber pad is damaged.
(15) Brake hose holder. Do not bend when tightening the nut, check the free space for the hose
(16) Lower hinge retaining ring
(17) Self-locking hex nut, replace.
(18) Lower axle joint. Replace only if rubber seal is damaged
(19) Hinge fastening. Attach to the hinge only after screwing to the guide rod. If installed incorrectly, the rubber gasket will be destroyed
* When removing the protective cap, pay special attention not to damage it. Through a damaged cap, water can get into the wheel bearing, causing it to break down in a short time. Therefore, bent caps should always be replaced.
Visitor comments