(1) guide rod, top
(2) rubber bearing. Insufficient sealing of the end face of the bearing may cause premature wear. Check: The head of the bolt and the washer of the nut must be centered in the bearing. If the bolt head or washer touches the bearing thrust washer, the wear limit has been reached and the bearing must be replaced. When checking the car must be on both wheels.
(3) washer
(4) eccentric disc. Install correctly
(5) washer. Bead for rubber
(6) damping ring
(7) kingpin. Install correctly, adjust camber after installation
(8) clamp
(9) rubber bearing
(10) stabilizer
(11) rubber bearing
(12) leg
(13) additional spring with protective tube
(14) spring pad
(15) spring. Install correctly.
(16) shock absorber
(17) guide rod (Bottom part)
(18) rubber-metal bearing
(19) , (20) hex bolt
(21) axial hinge (top part)
(22) tightening torque for hex bolts 160 Nm
(23) rounded fist
(24) tie rod
(25) tightening torque 30 Nm and tighten further up to the cotter pin hole
(26) replace self-locking nuts with a torque of 65 Nm, tighten with a torque of 70 Nm
(27) damper ring
(28) spacer sleeve
(29) washer, bead down
(30) traction brace. After installation, adjust the length (caster pitch)
(31) rubber bearing
(32) rubber bearing, guide bush
(33) spacer sleeve
(34) washers. The sides look from the bearing
(35) washer. side down
Visitor comments