Initial position
The marking on the upper part of the rail, at the rear, 1 must be on both sides between the marks a on the rocker rails 2 (pic. 8.46).
Slide guide 2 must be fixed in the guide rail (does not move by hand).
If this is not the case, adjust the parallel stroke.
Insert the sliding/tilting sunroof panel from above and tighten the screws (backstage / covers) (rice. 8.45).
Do not overtighten the screws.
NOTE: Tighten the screws after adjusting the panel height with a tightening torque of 4.5 Nm.
Visitor comments