The original position of the sliding/tilting sunroof must be correct.
Raise the glass panel.
Slide the sun shield back.
Release the bellows from the bottom bar, starting from the back of the hatch (rice. 8.44).
Then, release the bellows from the top bar, starting at the front of the hatch.
Pull the bellow back out of the slots and remove it.
Return the glass panel to its original position.
Adjust the height of the sunroof glass panel at the front and rear as shown in the illustrations to avoid abnormal driving noises.
Front panel adjustment: a = 0-1 mm below the roof plane. Arrow - direction of movement.
Rear panel adjustment: b = 0-1 mm above the roof plane. Arrow - direction of movement.
Tighten the glass panel screws with a tightening torque of 4.5 Nm.
Visitor comments