Instructions: The front section is adjustable only from the front, and the rear section is adjustable only from the back. To achieve the best possible appearance, it is necessary that the sections are equally adjusted to the left and right /symmetrically).
Height adjustment control
Using a depth gauge, check the adjustment of the front "1" and rear sections "2".
- Size "a": 1.5±1 mm
- Size "B": 1±1 mm
- Size "c": 1±1 mm
If the measured values differ from the nominal values, the corresponding section must be adjusted.
Front section adjustment
Instructions: You can start adjusting the position of the section only after it is completely closed (will no longer be in a shifted position).
Remove the bar. Loosen only the two front bolts "2" securing section "1" on the left and right. Close the hatch. Adjust the position of section "1" according to the figure.
- Size "a": 1.5±1 mm
- Size "b": 1±1 mm
- Size "c": 1±1 mm
Tighten the bolts on the left and right to 5 Nm. Install the bar.
Rear section adjustment
Slightly bend the inner seal "3" in the places "arrow" in the direction of the inside and loosen the bolts "2" of the rear section "1". Adjust the position of the rear section "2" in accordance with the figure.
- Size "a": 1.5±1 mm
- Size "b": 1±1 mm
- Size "c": 1±1 mm
Tighten the bolts to 5 Nm.
Visitor comments