General description (models with 2.4L engine) (VW Lt 28)

1. General description of the ignition system given in chapter 4, also applies to the ignition system installed on 6-cylinder engines, except for the obvious difference in the number of cylinders serviced.

2. Similarly, the procedures for maintenance and repair of the system are similar. The main differences will be discussed below.

3. When working with the ignition system installed on 6-cylinder engines, you should be guided by Specifications, given at the beginning of this Appendix.

Figure 13.43. Distributor disassembled: 1 - To the carburetor; 2 - Thermopneumatic valve; 3 - Vacuum ignition regulator; 4 - Contact breaker plate; 5 - Distributor; 6 - Mark for cylinder No. 1; 7 - Gasket; 8 - Clamp; 9 - Ignition wire; 10 - Spark plug cap; 11 - Spark plug; 12 - Terminal 1 (-); 13 - Damping valve; 14 - Breaker contacts; 15 - "Coal" with a spring; 16 - Distributor cap; 17 - Runner; 18 - Dust cover; 19 - Capacitor; 20 - Connector with built-in radio interference suppression; 21 - Terminal 4; 22 - Terminal 15 (+); 23 - Clamp; 24 - Ignition coil.

(The original can be found at www.VWManual.ru)

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

The text has been checked: Kolesnikov Artem

Previous articles
Ignition System Specifications — 2.4l models
Ignition system — troubleshooting
Spark plugs and spark plug wires — general information
Ignition coil — general information
Distributor — bulkhead
Distributor — removal and installation

Next articles
Breaker contacts replacement (models with 2.4L engine)
Distributor — removal and installation (models with a 2.4 l engine)
Engine speed limiter (models with 2.4L engine)
Spark Plugs and Wires (2.4L Models)
Vacuum ignition regulator (models with 2.4L engine)

General description (models with 2.4L engine) (VW Lt 28)

Visitor comments