1 - bolt, 45 Nm
2 - engine bracket
3 - Upper toothed belt casing
4 - toothed belt
If the belt is to be reinstalled, mark the direction of travel on the belt before removing it.
Do not break.
5 — bolt, 25 Nm
6 - nut, 25 Nm
7 — bolt, 20 Nm
8 - bolt, 45 Nm
9-camshaft gear wheel
10 - tension roller
11 - guide roller
12 — fuel injection pump gear
13 — bolt, 10 Nm
14 — bolt, 30 Nm
15 — bolt, 15 Nm
16 - rear toothed belt protective screen
17 — coolant pump
18 - guide roller
19 — crankshaft gear
20 — bolt, 30 Nm
21 — bushing
22 - nut
23 — Fuel injection pump
24 - Compact bracket for auxiliary units
25 — bolt, 45 Nm
26 — bolt, 120 Nm + 90° (¼ turn) in tightening direction
Always replace the bolt with a new one.
A holder is required for loosening and tightening. Do not apply additional motor oil or grease to the thread and flange. The tightening direction can be turned in several steps.
27 — bolt, 40 Nm + 90° (¼ turn) in tightening direction
28 - lower toothed belt casing
29 - middle toothed belt cover
30 — bolt, 10 Nm
(The original text can be found on the portal: VWmanual)
Visitor comments