Contents: Removal ↓ Installation ↓
Location of fastening elements of the front wing niche trim
- 1 - front wing niche trim,
- 2 - plastic nut,
- 3 - Phillips head screws 9 pcs.,
- 4 - nut
The gap sizes between the front body parts on Sedan models
- A - 1.0 mm,
- B - 2.5 mm,
- F - 3.0 mm,
- G - 3.5 mm,
- H - 4.0 mm
Rear body gap sizes on Sedan models
- A - 1.0 mm,
- F - 3.0 mm,
- G - 3.5 mm,
- K - 5.0 mm
The size of the gaps between the parts of the rear part of the body of the station wagon cars
- A - 1.0 mm,
- F - 3.0 mm,
- G - 3.5 mm,
- H - 4.0 mm,
- K - 5.0 mm
Removal
1. Loosen the front wheel mounting bolts, then raise the front of the car and secure it on stands. Remove the front wheel.
2. Remove the 9 Phillips head screws securing the front wheel well trim.
3. Remove the front wheel well trim from under the wing arch.
Installation
1. Install the front wheel well trim under the front fender arch and secure with 9 screws.
(The original material is available on the portal: VWmanual.ru)
2. Install the front wheel, then lower the vehicle to the ground. Tighten the wheel mounting bolts in a diagonal sequence to 120 Nm.
Visitor comments