Hang the front of the car and remove the wheel.
Remove the brake fluid from the brake master cylinder reservoir with a syringe.
Disconnect the hose from the wheel cylinder.
Loosen the two bolts securing the shoe guide to the steering knuckle.
Unscrew the bleed valve from the cylinder body and remove the guide assembly with the caliper.
Close the fitting hole in the wheel cylinder with a plug.
Before installation, wash all parts of the brake mechanism with alcohol, dry and check their technical condition.
Screw the bleed screw into the wheel cylinder.
Install the shoe guide assembly with the caliper on the steering knuckle.
Screw in the bolts securing the guide pads to the steering knuckle and tighten them to a torque of 7.0 kgf·m.
Pour brake fluid into the master cylinder reservoir.
Bleed hydraulic brakes.
Install the wheel.
Visitor comments