Contents: Removal ↓ Installation ↓
Removal
Disconnect the ground wire from the battery.
Remove cover 8 (figure 163) or 1 (figure 164) ignition distributor, disconnect the vacuum hose from the vacuum regulator chamber.
Figure 1b3. Ignition distributor sensor (with Hall sensor): 1 - sensor-distributor housing; 2 - bolt (10 Nm); 3 - vacuum regulator chamber; 4 - bearing cap; 5 - dust shield; 6 - runner; 7 - coal; 8 - distributor sensor cover; 9 - screen; 10 - connector plug; 11 - "Hall" sensor; 12 - sealing ring
Figure 164. Ignition distributor sensor (with contact group): 1 - distributor sensor cover; 2 - coal; 3 - runner; 4 - plastic casing; 5 - lid latch; 6 - contact group; 7 - bolt; 8 - vacuum regulator chamber; 9 - capacitor
Loosen the ignition distributor mounting bolts and remove the ignition distributor.
Installation
The ignition distributor mount is eccentric, which ensures that the ignition distributor can be installed in only one possible position (correct) position.
Proceed with the installation as follows:
- Install the ignition distributor with a new gasket and slowly rotate the distributor shaft until it engages with the camshaft. Lightly tighten the distributor mounting bolts.
- Place the combustion distributor sealing washer and runner on. Rotate the runner slightly when installing it so that it snaps into the locking groove.
- Before installing the distributor cap, check it for cracks. Check the degree of wear of the contacts. Clean the contacts and the cap.
- Check the degree of wear and mobility of the carbon contact and spring.
- Install the ignition distributor cap. There is a mark on the ignition distributor housing. When putting the ignition distributor cap on, the ignition wire of cylinder 1 is located above the mark in the ignition distributor cap. Next, in the direction of rotation of the ignition distributor striker, there are ignition wires of cylinders 3-4-2.
- Connect the ground wire to the battery.
- Connect the vacuum hose to the vacuum box on the ignition distributor.
- Adjust the ignition timing.
Visitor comments