- a) When installing the units into the engine chamber, ensure that the drive axle shafts are minimally bent.
- b) Tighten the engine mount cushions first slowly and tighten them only when the drive unit is installed correctly and none of the suspension elements is too tense. Tighten the engine mount bolts to the appropriate torque (see figure 1.12 and figure 1.13).
- c) Adjust the clutch clearance.
- d) Adjust the throttle cable and, if available, the starting equipment throttle cable.
- d) Add oil and coolant to the engine.
Fig. 1.12. Drive unit suspension bracket bolts
1 - 50 Nm, 2 - 45 Nm; 3 - 35 Nm; 4 - 70 Nm
Figure 1.13. Drive unit suspension brackets
1 - 36 Nm 2 and 4 - 25 Nm 2 and 4 - 45 Nm 3 - 80 Nm
The original article is posted on the website vwmanual.ru
Visitor comments