Clutch rod
In the engine compartment near the gearbox, pull up on the clutch fork lever so that the tip hangs freely.
Apply a small amount of grease around the end of the cable sheath. Press the clutch pedal several times to lubricate the cable sheath.
Handbrake rods
The handbrake is operated by two cable pulls. For lubrication, it is best to use water-resistant consistent lubricants, such as "Molikot BR 2 plus", which is also suitable for lubricating rear wheel bearings.
Remove the protective corrugated cuff from the rods where they enter the casings.
Apply a small amount of grease at the entrance to the shells and put on the corrugated cuffs.
Throttle actuator
Remove any adhering dirt from all moving parts.
Lubricate them with a small amount of engine oil. Press the gas pedal several times to lubricate all moving parts.
Sliding sunroof
Wipe the sliding sunroof guides until they are clean.
Lubricate the guides with silicone paste or aerosol.
If you lubricate with regular grease, the hatch may become dirty.
Visitor comments