35. Pull the air damper cable out so that the serrated disc is facing its highest protrusion.
36. Loosen the choke block cover mounting screws and turn the cover counterclockwise until the air damper closes. Tighten the cover screws.
37. Move the air damper control rod to the stop by placing a screwdriver on the adjusting screw (1) and pushing it in the direction indicated by the arrow (see Figure 13.27) i.e. in the direction of the air damper lowering block.
Figure 13.27. Adjusting screw (1) of the air damper starting gap (1B1 carburetor) (Section 6A).
38. Using a drill of a suitable diameter, measure the gap between the edge of the valve and the carburetor wall.
Figure 13.28. Checking the air damper starting gap (1B1 carburetor) (section 6A): 2 - Drill for measuring the gap
39. Using the screw (1), adjust the starting gap until the required value is achieved.
(View the original on this resource: www.VWmanual.ru)
40. Turn the choke block cover back to its original position (so that the installation marks align).
Visitor comments