Manual choke unit — removal, installation and adjustment (models with a 2.0 l engine produced since 1980) (VW Lt 28)

4. Disconnect the choke control cable from the carburetor.

5. Loosen the choke block cover screws and remove the cover.

6. When replacing the cover, check that the bimetallic spring is engaged with the air damper control lever and that the opening lever is to the left of the control lever.

Figure 13.22. Installing the choke block cover (1B1 carburetor) (Section 6A): 1 - Bimetallic spring; 2 - Control lever; 3 - Opening lever.

7. Insert the choke cover screws and before tightening them, adjust the position of the choke cover so that the alignment marks align.

Figure 13.23. Choke block cover alignment marks (shown by arrows) (1B1 carburetor) (Section 6A).

The original can be seen on the portal (vwmanual.ru)

8. When tightening the cover screws, press the latter against the guide protrusions on the choke unit body.

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

The text has been checked: Kolesnikov Artem

Previous articles
General description — models with a 2.0l engine produced since 1980.
Fuel system specification — 2.4l engine
Fuel system — troubleshooting
Manifolds and exhaust system — general information
Exhaust Gas Afterburning System — description and maintenance
Throttle Pedal Cable — adjustment

Next articles
Idle speed and mixture control (2.0L engine models produced since 1980)
Air damper starting clearance — adjustment (models with 2.0l engine produced since 1980)
Accelerator pump — regulation (models with 2.0l engine produced since 1980)
Choke cable (manual choke models) — general operating principles and adjustment
Throttle Damper and Timing Valve — checking and adjusting
Modified mixture enrichment valve (since November 1980)

Manual choke unit — removal, installation and adjustment (models with a 2.0 l engine produced since 1980) (VW Lt 28)

Visitor comments