Contents: Standard lamp ↓ Halogen lamp ↓
1. Loosen the screws of the front headlight panel and remove the panel (see photo 16.1).
Figure 10.12. Headlight panel mounting screws (D) (Section 16).
Photo 16.1. Removing the front headlight decorative panel.
2. Loosen the screws securing the headlight bezel and remove the headlight. Do not move the headlight beam adjustment screws (see photo 16.2).
Figure 10.13. Headlight screws (Section 16): A - Adjusting screw; B - Adjusting screw; C - Fastening screw.
Photo 16.2. Unscrewing the screw of the front headlight mounting ring.
Standard lamp
3. Disconnect the wiring plug from the back of the headlight and remove the rubber dust cap (see photo 16.3).
Photo 16.3. Removing the headlight dust cap.
Figure 10.14. Lamp (standard type) — components (Section 16): 1 - Dust cap; 2 - Fastening ring; 3 - Lamp/socket; 4 - Front side light.
4. Turn the lamp holder retaining ring and remove it.
5. Remove the socket and lamp assembly (her. photo 16.5).
Photo 16.5. Removing the headlight bulb.
6. Insert the new cartridge so that the mounting tabs align.
7. Install the mount, plug and dust cap.
8. Replace the headlight and tighten the mounting ring screws.
Halogen lamp
9. Disconnect the electrical wiring plug from the rear headlight housing and remove the dust cap.
10. Press the ends of the retaining clip together and remove it.
Figure 10.15. Lamp (halogen type) - components (Section 16): 1 - Dust cap; 2 - Fastening spring clamp; 3 - Lamp/socket; 4 - Front side light.
11. Lower the lamp, holding it with a piece of paper, and remove it. Install the new bulb, again holding it with a piece of paper, and making sure the center tab is higher than the others. Never touch the glass of halogen lamps with your fingers, as this will greatly reduce their lifespan. If you accidentally touch the lamp, wipe its glass with methyl alcohol.
12. Place the retaining clip over the lamp socket, press the ends of the clip together and insert them into the retaining tabs.
13. Install the rubber dust cap and connect the electrical plug.
14. Replace the headlight and tighten the mounting screws.
Visitor comments