Adjusting the accelerator drive (VW Beetle)

Install the accelerator cable on the clamp bolt so that when the accelerator pedal is fully depressed (the assistant presses it) there was a gap "a" of 1.0-1.5 mm between the throttle lever and its stop on the carburetor body.

(The information is posted on this website VWmanual.ru)

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

The text has been checked: Kolesnikov Artem

Previous articles
Checking the fuel-air mixture shut-off valve
Removal and installation the carburetor
Fuel supply problems
Carburetor adjustment
Carburetor — design description
Maintenance of the power supply system

Next articles
Disassembling the carburetor
Removal, checking and installation the float needle valve
Checking and adjusting idle speed
Checking and adjusting the CO content in exhaust gases
Adjusting the throttle closing damper
Throttle valve adjustment

Similar articles from other manuals for VW cars:
Checking and adjusting the performance of the accelerator pump Passat B3 (1988-1993)
Adjusting the accelerator pedal drive (for automatic… Golf 1 (1974-1984, diesel)
Adjusting the accelerator cable Polo 3 (1995-2003)
Electronic engine power control (electronic accelerator drive) Touareg 1 (2002-2006)
Accelerator drive parts and components Tiguan 1 (2007-2015)
Adjusting the tension of the drive belt of engine units Sharan 1 (1995-2000)
Adjusting the shift drive and checking operation Transporter T4 (1990-2003)

Adjusting the accelerator drive (VW Beetle)

Visitor comments