Contents: Removal ↓ Installation ↓
Removal
Remove the air filter.
Disconnect the electrical wires from the automatic starter and the fuel-air mixture shut-off valve.
Disconnect the fuel and vacuum hoses from the carburetor.
Disconnect the accelerator rod, unscrew the clamping screw.
Using a 13mm offset open-end wrench, loosen the two hex bolts on the bottom of the intake manifold flange.
Remove the carburetor and sealing gasket.
Cover the inlet of the intake manifold with a clean rag.
Installation
Caution! Use a new sealing gasket between the flange and the inlet manifold.
Place the gasket, install the carburetor and lightly tighten its mounting bolts.
The original material is available on the portal: vwmanual
Insert the accelerator rod into the clamping screw and adjust the rod.
Connect the electrical wires to the automatic starting unit and the fuel-air mixture shut-off valve.
Connect the fuel and vacuum hoses; secure the fuel hoses with clamps. Attention! Use clamps N 023 558.1.
Install the air filter.
Adjust the idle speed (see section below "Checking and adjusting idle speed").
Visitor comments