Second row of seats
Removal
1. Lower the headrest down until it rests against the seat back.
2. Pull the lever at the front of the seat up and move the seat all the way back.
3. Grasp the loop on the side of the seat and fold the backrest forward onto the seat cushion.
4. Pull the loop on the back of the seat cushion and fold the cushion forward along with the backrest.
5. Push forward (see arrows in the illustration) two locking levers 1 on the floor on the left and right sides of the seat and lift the seat up, holding it by the handle, and release it from the fastening 2.
Installation
6. Install the seat onto the mounting bolts, press down both locking levers and tilt the seat back.
Further installation of the seat is carried out in the reverse order of removal. In this case, make sure that the seat is tightly seated on the anchor bolts.
Third row of seats in a seven-seater vehicle
Removal
7. Unscrew two bolts 1 and 2 from the floor. Push forward (see arrows) two locking levers 1 on the floor on the left and right sides of the seat on the right side of the seat (see illustration).
8. Unscrew four bolts 3 and 4 (see illustration 36.7).
9. Fold the right seat back forward and remove the right seat 7 (see illustration 36.7).
10. Unscrew two bolts 5 and 6 from the floor on the left side of the seat (see illustration 36.7).
11. Fold the left seat back forward and remove the left seat 8 (see illustration 36.7).
Installation
The installation of the seats is carried out in the reverse order of removal.
(The original text can be found at: «VWMANUAL»)
The seat mounting tightening torque is 55 Nm.
Visitor comments