Contents: Switch A ↓ Switch B ↓
Switches A and B are used to adjust the seat position using the electric drive.
Regulation is also carried out when the ignition is off.
The handwheel C is used to mechanically adjust the support in the lumbar region.
Warning: For safety reasons, the seat height should only be adjusted when the vehicle is stationary.
Warning: Be careful when adjusting the seats! Inattention or carelessness can cause injury.
Warning: The electric seat adjustment also functions when the ignition is switched off and the ignition key is removed. Therefore, children should never be left alone in the vehicle without adult supervision.
Switch A
(The original text can be found at: www.VWManual.ru)
The position of the seat is adjusted by pressing the switch in the directions of the arrows.
- 1 - seat forward/backward
- 2 - front seat plane up/down
- 3 - rear seat plane up/down
- 2 and 3 - simultaneous seat height adjustment
Switch B
The position of the seat back is adjusted by pressing the switch in the directions of the arrows.
In the direction of arrow 1 – increase the angle of the backrest.
In the direction of arrow 2 – decrease the angle of the backrest.
Warning: When driving, the seat backrests should not be reclined too far back, as this will reduce the effectiveness of the seat belts.
Visitor comments